AS/NZS ISO 11297.2:2023 identically adopts ISO 11297 2:2018, which specifies the requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground drainage and sewerage networks under pressure. Applicable to polyethylene (PE) pipes of three different types, PE solid wall single layered pipes, PE pipes with co-extruded layers and PE coated pipes with a peelable, contiguous, thermoplastics additional layer
Table of contents
Header
About this publication
Preface
National Foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
4.1 Symbols
4.2 Abbreviated terms
5 Pipes at the “M” stage
5.1 Material
5.2 General characteristics
5.3 Material characteristics
5.4 Geometrical characteristics
5.5 Mechanical characteristics
5.6 Physical characteristics
5.7 Jointing
5.8 Marking
5.9 Regional requirements for pipes
6 Fittings at the “M” stage
6.1 Requirements
6.2 Marking
6.3 Regional requirements for fittings
7 Ancillary components
8 Fitness for purpose of the system for pipes and fittings at the “I” stage
9 Installation practice
9.1 Preparatory work
9.2 Storage, handling and transport
9.3 Equipment
9.3.1 Butt fusion equipment and de-beading equipment
