Header
About this publication
Preface
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protective measures
5.1 Mechanical hazards
5.1.1 General
5.1.1.1 Basic requirements
5.1.1.2 Safeguards
5.1.1.3 Safety distances
5.1.2 Feed equipment area
5.1.2.1 Horizontal baling presses fed by conveyors
5.1.2.2 Horizontal baling presses fed by bin lifts
5.1.3 Feed hopper area
5.1.3.1 Horizontal baling presses fed by conveyors
5.1.3.2 Horizontal baling presses fed by cranes, lift trucks, mobile plant or bin lifts
5.1.3.3 Manually fed horizontal baling presses
5.1.3.4 Feed hoppers equipped with an access door
5.1.4 Baling chamber area
5.1.5 Wire guidance zone
5.1.6 Bale channel and wire tying area
5.2 Hazards due to failures in the control system or unexpected start-up
5.2.1 Control devices
5.2.2 Prevention of unauthorised operation
5.2.3 Emergency stop
5.2.4 Required performance levels PLr according to EN ISO 13849-1
5.3 Electrical hazards
5.4 Hazards from hydraulic equipment
5.5 Slips, trips and falls
5.6 Noise hazards
5.6.1 Noise reduction at source by design
5.6.2 Noise reduction by protective measures
5.6.3 Information connected with noise hazards
5.7 Hazards due to neglecting ergonomic principles in the design of the machine
6 Verification of the safety requirements and/or protective measures
7 Information for use
7.1 General information
7.2 Information for safe operation
7.2.1 General
7.2.2 Summary of operating instructions
7.2.3 Information on noise
7.2.4 Setting and maintenance instructions
7.2.5 Instructions for the replacement of coils
7.2.6 Spare parts list
7.2.7 Preventing faults and fault recovery
7.2.8 Information for preventing and removing blockages in the feed hopper
7.2.9 Information for preventing faults and troubleshooting on the bale tying equipment (e.g. in the event of a broken bale wire)
7.2.10 Information on periodic examinations and examinations following repairs and modifications
7.3 Marking
7.3.1 Manufacturer’s plate
7.3.2 Safety signs
Annex A
A.1 Scope
A.2 Determination of emission sound pressure level at the work station(s)
A.2.1 Basic standards
A.2.2 Measurement uncertainty
A.3 Determination of sound power levels
A.3.1 Basic standards
A.3.2 Measurement uncertainty
A.4 Installation and mounting conditions for the noise measurement
A.5 Operating conditions
A.6 Information to be recorded and reported
A.6.1 General
A.6.2 Horizontal baling press data
A.6.3 Standards used
A.6.4 Noise data
A.6.5 Installation and operating conditions
A.7 Declaration and verification of noise emission values
Annex B
Annex ZA
Bibliography
Appendix ZZ
ZZ.1 Scope
ZZ.2 Variations
